Step 1: Remove the tailgate on an 8 ft. bed and install the rear mounting bracket as shown. See photos at the end of this sequence for short bed installations and for the LX Models that allow the tailgate to remain in place and functional.

Step 2: Position the TK Loader behind the pickup & use the handheld remote to extend the loader to the full out position. The internial battery on this model allows the unit to operate in & out of the vehicle.

Step 3: Carefully lift the forward end of the loader & place the cross-member on the end of the pickup bed as shown.

Step 4: Move to the rear of the loader and carefully lift to the horizontal position.

Step 5: Slide the loader forward until the lower frame comes in contact with the front of the pickup bed.

Step 6: Using the handheld remote, retract the top deck to the full in position.

Step 7: Center the loader on the pickup bed and attach therear mounting bracket using a 3/4

Step 8: Attach the forward braces to the side of the loader frame and position under the lip of the bed. Make certain that the forward end of the TK Loader is centered in the truck bed. Either measure from side to side or compare to the seams in the bottom of the truck bed.

Step 9: Connect the power cord to the vehicle battery (or cigarette lighter/power point if equipped with an internal battery). This cord may be run through the rear sliding window if available or it may be passed through the driver

Short bed mounting bracket shown here.